XEROX 7755

[bmt_hr]

Hi

I have problem with yellow color. Look on the picture (in circle). The yellow passer is not on the right position.
On every picture yellow is around 1 mm on some side moved.... Where can be a problem?

br

[InterfaceP]

Re: XEROX 7755

Under test patterns run a #1 full color. This will show you how off it is.

Several things could be causing this, a faulty MOB sensor or a bad drum among others.

I typically take off the left side panel along with Tray 5. so I can see the IBT belt running as you run the following tests:

Registration Control Setup cycle
Registration Control Sensor Check Cycle
Registration Measurement Cycle

If the chevrons are damaged the MOB sensor will not properly register them, also check the MOB for broken shutters.

If on any of the tests you get a NG something is off.