Xerox 550 booklet fold position

[azehnali]

anyone know how to adjust the fold position on light production finisher?

[Dech]

Re: Xerox 550 booklet fold position

hi. go into service mode. maintanance, adjusments, finisher adjust, fold only- will adjust the centre fold, top page to long, take adj down, top to short, add to . staples not in centre fold, set fold and staple. i find the best is to start with 2 x a4 pages, 3 x a4 pages, 4 x a4 pages, 7 x a4 pages, 14 x a4 pages, do the same with a3 - 2,3,4,7,14. if adjustments dont move the paper much, clear the finisher nvms, add all back according to the finisher nvm sheet, then start setting all the sizes and folds

[azehnali]

Re: Xerox 550 booklet fold position

hi. go into service mode. maintanance, adjusments, finisher adjust, fold only- will adjust the centre fold, top page to long, take adj down, top to short, add to . staples not in centre fold, set fold and staple. i find the best is to start with 2 x a4 pages, 3 x a4 pages, 4 x a4 pages, 7 x a4 pages, 14 x a4 pages, do the same with a3 - 2,3,4,7,14. if adjustments dont move the paper much, clear the finisher nvms, add all back according to the finisher nvm sheet, then start setting all the sizes and folds

Thanks
will try

[grcmptrnrd]

Re: Xerox 550 booklet fold position

add all back according to the finisher nvm sheet, then start setting all the sizes and folds

Is the finisher nvm sheet usually hidden somewhere in the finisher like the copier's sheet in Tray1?

[grcmptrnrd]

Re: Xerox 550 booklet fold position

clear the finisher nvms, add all back according to the finisher nvm sheet, then start setting all the sizes and folds

Also, other than the folding / stapling positions, are there any nvms that are important if all is working well?