xerox 700 wont power on

[adriansto]

Re: xerox 700 wont power on

If he is a xerox tech is good to read and follow the edoc procedures mainly from chapter 4 chain 3.
If he's not it's your assuming risk.

[subaro]

Re: xerox 700 wont power on

So you had two xerox techs out to help you and they are telling to ask for help. the second tech should have been aware of where you stand in the troubleshooting process and he should have been prepared before he came out. and what, a xerox tech who never replaced a engine pwb. i guess you have to call him only when you need to replace feed tires, that is rediculous. i found a xerox machine with an ess pwb and the replacment procedures. It is pretty straight foward as they are just warning to change one eeprom at a time so that you would not get them mixed up. so in that case find a way to mark the two original or how many there are on the original board and put them on the replacement board. so essentially DO NOT GET THEM MIXED UP. download th pdf file and NOTE it not from a 700. It is just the procedure on how to replace it on the 790,and most likely it is the same for the 700. The part to change the language code i won't do as the board you are using already is from your destination.
Maybe someone has the page from a 700 service manual on the procedure.

http://www.soft-manufaktura.ru/manual/xerox/Phaser790_DocuColor%202006.pdf

page 264

[lion_heart]

Re: xerox 700 wont power on

So you had two xerox techs out to help you and they are telling to ask for help. the second tech should have been aware of where you stand in the troubleshooting process and he should have been prepared before he came out. and what, a xerox tech who never replaced a engine pwb. i guess you have to call him only when you need to replace feed tires, that is rediculous. i found a xerox machine with an ess pwb and the replacment procedures. It is pretty straight foward as they are just warning to change one eeprom at a time so that you would not get them mixed up. so in that case find a way to mark the two original or how many there are on the original board and put them on the replacement board. so essentially DO NOT GET THEM MIXED UP. download th pdf file and NOTE it not from a 700. It is just the procedure on how to replace it on the 790,and most likely it is the same for the 700. The part to change the language code i won't do as the board you are using already is from your destination.
Maybe someone has the page from a 700 service manual on the procedure.

http://www.soft-manufaktura.ru/manual/xerox/Phaser790_DocuColor%202006.pdf

page 264

yea, he said he didn't did it in years so can't get mad with him for being honest rather than do something and mess it up. also he wasn't supposed to be there, kinda did a side favor as he could get fired from xerox for it. he was there really to point me in the right direction.

got the new board it, synced the boards up fine. powers up, just getting an error 045-315, going to see what connector i probably didn't seat properly on the ROS now.