Xerox 700i error 010-319 can anyone help

[Corder]

Re: Xerox 700i error 010-319 can anyone help

Is there a UI mode for the 700 and 700i and can a tech troubleshoot or test some functions of the machine in this mode.

Yes, of course.

[subaro]

Re: Xerox 700i error 010-319 can anyone help

Man, 700i and wc7132 have little differences between each other

Oh, I knew that, but just wanted to get the feedback. so here is a question. Is there a UI mode for the 700 and 700i and can a tech troubleshoot or test some functions of the machine in this mode.


Just learning about this machine, so be patient.

[xtrain]

Re: Xerox 700i error 010-319 can anyone help

Thanks guys. I think he got the message.

[Corder]

Re: Xerox 700i error 010-319 can anyone help

According to fault manual

010-319 Fuser Center Thermistor Differential Amp RAP


WorkCentre 7132Service DocumentationWorkCentre 7132705P01181 (EDOC/SGS)RevisionJanuary 20

troubleshoot the fusing unit, check the thermistors. and connectors.

Man, 700i and wc7132 have little differences between each other

[subaro]

Re: Xerox 700i error 010-319 can anyone help

According to fault manual

010-319 Fuser Center Thermistor Differential Amp RAP


WorkCentre 7132Service DocumentationWorkCentre 7132705P01181 (EDOC/SGS)RevisionJanuary 2007

troubleshoot the fusing unit, check the thermistors. and connectors.

[Corder]

Re: Xerox 700i error 010-319 can anyone help

?????????????????????? Realy ?????????

Procedure
It may be necessary to set NVM [744-361] to 0 in order to clear this failure.


Check that there is no foreign object on the Heat Roll surface and no paper wound around it.


Check the Fuser Sensors are free of dirt.


Check that the Drawer Connectors connecting the Fuser Unit and the main unit are free from bent pins, foreign objects and burnout.


Replace the Fuser Assy ( PL 8.1)

[adriansto]

Re: Xerox 700i error 010-319 can anyone help

The 700i edoc says set nvm 744-316 to 0, not 744-315.

?????????????????????? Realy ?????????

[xtrain]

Re: Xerox 700i error 010-319 can anyone help

The 700i edoc says set nvm 744-316 to 0, not 744-315. It states to check fuser heat sensors and fuser drawer connector for bent pins, dirt, or burnout. Then to replace fuser assembly.

[1mcfilhos]

I have a xerox 700i and i have the error 010-319 i have already chang the nvram 744-351 to 0 but same problem