CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC7675 )

[600k]

I got a problem with my C7600(Asia Model). [Apeosport-III C7600 (similar to DC240 / DC242 / DC250 / WC7665 / WC7675 )]

Problem is CMYK miss alignment.




I already do next 3.

Regi Measuring Cycle - result ok
Registration Control Sensor Check Cycle - result ok
Registration Control-Setup Cycle




Y,K align is similar & C,M align also similar.


What can I do next?
Please, help me.
c7600_misalignment.JPG

[copytech200X]

Re: CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC767

what did u do before this issue happen?probably shorting wire due to remove and reinstall motor assy

[Mukasa]

Re: CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC767

what did u do before this issue happen?probably shorting wire due to remove and reinstall motor assy

Hi Boss,
Pull out the MOB sensors, clean them properly and its mechanism should be working fine,put them back then run REGICORN. Reboot and test again.

[copytech200X]

Re: CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC767

since the initial steps our friend already chk all 3 regi adj are OK ..if MOB sensor assy got dirt should failed on the 1st or 2nd steps.

[600k]

Re: CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC767

what did u do before this issue happen?probably shorting wire due to remove and reinstall motor assy

I just moved this Machine to other place.

Actually I don't know when it happened. I just found it.

[600k]

Re: CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC767

Hi Boss,
Pull out the MOB sensors, clean them properly and its mechanism should be working fine,put them back then run REGICORN. Reboot and test again.

I already check it, But result is same~!

thanks~!

[Zeedras]

Re: CMYK Misalignment in Apeosport-III C7600 ( DC240 / DC242 / DC250 / WC7665 / WC767

[QUOTE=600k;472035]I just moved this Machine to other place.

Actually I don't know when it happened. I just found it.[/QUOTE

1st factor of color misregistration is ros unit, 2nd is mob and 3rd is mcu pwb. As you said, you
move the machine to other place, maybe the ros unit was damaged. Hmmmn, try these steps b4 suspectng Ros replacement.
initialize first the iot nvm then proceed to regicon setup cycle, regicon sensor check, regi measurement
cycle.