Gr3750 print speed problems

[ybnews]

My GR 3750 will only feed consistantly if I set the print speed at #2 speed setting. Any speed higher that that It only prints 3 copies then indicates "paper misfeed, press reset" message. Seems like a timing problem.
Any suggestions on how to fix?
Thanks,
Dana Lewis

[joelsa12]

Where is the Jam?

Where is it indicating a jam. Under drum or at the pick up. How many copies are on the machine. Did you adjust the stripper angle? Are you feeding 20# bond?

[johngallowayiii]

There is a clutch on the exit side of the machine that will bind up and when you go to speed 3 or higher it will jam. try cleaning it or replace it and that seems to solve the problem.

[Kopyrtek]

More than likely your problem is as johngallowayiii said. The clutch that runs the transport bed has gone bad and you need to replace.But,also check the set screw on the drive of the transport to make sure it hasnt backed out