Riso V8000 master with wrikkels on drum

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Risocenter

    #1

    Riso V8000 master with wrikkels on drum

    If my V8000 is making a new master and putting it onto the drum (first and sec drum) there are existing a lot of wrikkels to the master. The result is of course a damaged image.
    The master is fitting well under the clamp.
    Has anybody experience with this phenomen.
  • mikadonovan
    Senior Tech

    Site Contributor
    2,500+ Posts
    • May 2008
    • 2931

    #2
    Originally posted by Risocenter
    If my V8000 is making a new master and putting it onto the drum (first and sec drum) there are existing a lot of wrikkels to the master. The result is of course a damaged image.
    The master is fitting well under the clamp.
    Has anybody experience with this phenomen.
    Not on this particular model. However, on other Riso models I have seen this when the master roll spins too freely causing a lack of tension which results in wrinkling. Also, make sure your master material feed path is free from anything that will cause it to skew. The leading edge of your master must be even from side to side under the clamp.
    NEVER ASSUME ANYTHING

    Comment

    • igorbirokip
      Technician
      • Apr 2010
      • 24

      #3
      Re: Riso V8000 master with wrikkels on drum

      Please if You have drivers for V8000 win XP ...... Send me link igorbirokip@gmail.com
      Thanks

      Comment

      • Huckleberry
        Junior Member
        • Dec 2011
        • 8

        #4
        Re: Riso V8000 master with wrikkels on drum

        Originally posted by igorbirokip
        Please if You have drivers for V8000 win XP ...... Send me link igorbirokip@gmail.com
        Thanks
        I remember from the past if I had this problem the cause was in my case the use of a KATUN master roll.
        It means: no original Riso. Other posibill causes are mentioned already.
        Regards, Chris Bergher from Amsterdam, The Netherlands.

        Comment

        Working...