If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have this Riso 3700 that has always forced the customer to jut the print poistion 3/8 on everything printed. Is there a way to change the permenant setting.
Thanks
Tim
Not only is there a way to change this but there are two ways to do this. One is through test mode (write start pos adjustment) and the other is a mechanical adjustment on the timing of the machine.
Comment