Hi,
I was just doing a small run of 200gsm prints and near the end the machine made an unusual noise, almost like a little pop, and the screen went blue. I smelt a faint burning smell. Shitting myself I turned it off straight away and left it for a while. After turning it on expecting an error message there was none. I tried a few prints and it ran 10 absolutely fine.
I've got a big job coming up in 3 weeks (62'000 sheets). I'm really scared about taking it on now.
Has anyone else experienced anything similar? Should I be looking for a spares machine? I've had my eye on a GR3750 on ebay, if I get that will most of the parts work on my GR3770?
Thanks
I was just doing a small run of 200gsm prints and near the end the machine made an unusual noise, almost like a little pop, and the screen went blue. I smelt a faint burning smell. Shitting myself I turned it off straight away and left it for a while. After turning it on expecting an error message there was none. I tried a few prints and it ran 10 absolutely fine.
I've got a big job coming up in 3 weeks (62'000 sheets). I'm really scared about taking it on now.
Has anyone else experienced anything similar? Should I be looking for a spares machine? I've had my eye on a GR3750 on ebay, if I get that will most of the parts work on my GR3770?
Thanks
Comment