HL-2030

[pepito17]

All light diodes, try Reset does not, the drum and toner are new to 150 copies.

[cosmin_mocanu]

try change the corona wire, of the image unit. And alsoo clen the corona asembly.

[CopierTechofOmens]

Do you have an error message?

[CopierTechofOmens]

From the status monitor on the computer that is

[pepito17]

From the status monitor on the computer that is

printer only fan working, diodes flashing constantly, I can not print ...

[CopierTechofOmens]

There is no status monitor installed for the printer on your computer? You probably have a fatal error code. Without an error code it is hard to diagnose. Most common fatality would probably be fuser related.

[mitatech]

All light diodes, try Reset does not, the drum and toner are new to 150 copies.

I have service manual. mail? I send.

[pepito17]

I have service manual. mail? I send.

I will very grateful, emaiepito17@abv.bg
thanks!!!

[pepito17]

e-mail: pepito17@abv.bg

[mitatech]

Check mail.

[pepito17]

Check mail.

Thank you very much, the problem is located ...."Fuser unit failure".
Thanks!!!

[pepito17]

now looking part number of the fuser, if you know please write it..

[vale24]

hi

Could you send and at me. My email is: vale24@dir.bg

[mitatech]

now looking part number of the fuser, if you know please write it..

Check mail.

[E Winter]

Take care to order the correct fuser unit - afaik there are two different versions out there. If the thermistor connector on the main pcb is red you'll need to order the "S" version.