Brother DCP-9045CDN "print unable 32"

[chairsurvivor]

I have a brother DCP-9045CDN, and the error show up as "print unable 32", I looked how to get into the maintenance mode, but I don't know what code I should enter in to clear this message permanently. Or is there something else I should be looking for that would cause this error. Send me a message with any thought on the matter.

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads


Paul@justmanuals.com

[Brett207]

Gidday,
You should check the transfer belt unit for any dirt, scratches or damage. If it is damaged or worn out, replace it with a new one.
After this, check the density sensor for dirt or damage.

Good luck

[chairsurvivor]

no it all looks good, all the parts are still fairly new.

[Brett207]

Check all of your drum units and toner cartridges for uneven wear, or damage.
Are you using genuine cartridges, or aftermarket refilled toner cartridges.
Some refilled toners can cause problems like this,

[chairsurvivor]

it all OEM but it's unfair to say refills would be the cause seeing how OEM can fail just as easy, clearly, but that aside. once again everything is still new looking, all about 80% on each consumable part. optics are clean looking.

[good]

Re: Brother DCP-9045CDN "print unable 32"

I'm sure this error will occur only if you have bad toner, drum and busted fuse.

Please check those carefully and make sure they are clean.