Brother HL 5250dn, Ghoust problem after replace Drum cartrige!!???

[Iascopi]

Hi All,

After replace drum cartrige on Brother HL 5250DN, cames on the Ghoust problem!
Usually when I have had this problem, after replace the drum cartrige the ghoust problem was resolved, but now it still presist!?!


total print pages:56452 prints
Replaced Toner cartrige:9
Replaced Fuser unit:0
Replaced Laser unit:0


P.S.(When the printed page is stoped before the fuser the "Ghoust print" presist)


If somebody can help, thank`s in advance!

[paultuk]

Re: Brother HL 5250dn, Ghoust problem after replace Drum cartrige!!???

Hi,

I have seen over 100 Brother printers with ghosting problems.
Usually after trying a new drum and toner I notice the fuser has a gradual build up of baked on toner on it. Or the fuser is badly scored by the spring guides located on the roller.

As the fuser roller builds up with toner the surface temperature of the roller decreases which decreases the fusing ability of the toner on the page which creates this repetitive ghosting down the page.

Take a look at the following image.
photo 1.jpg

I'd look a the fuser and go from there.

All the best!

Paul

[Elmtech]

Try a new toner has resolved it the past for me. Also check the hv contacts in the frame

[Dickie]

Re: Brother HL 5250dn, Ghoust problem after replace Drum cartrige!!???

Did you reset the drum counter when you installed the new drum ?
The machine adjusts the main charge level during the life of the drum and it resets it only when you tell it that it has a new drum.
Also are you using original brother consumables ?
If as you say it is ghosting before fusing then it can only be a drum or toner issue