If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had a HP CP4525 printer that was giving a 59.F0 error at every boot up, making the printer unusable. The cause turned out to be a failed DC Controller.
Wish I had your post a few months back. We put a lot of time and parts into this problem because I guess 99/100 it's the fuser drive pack with a sticky solenoid that causes this. Mine too was the DC Controller.
Comment