XP PageWide Pro MFP 477dw error 0xc6fd0002

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • KeshaTotenkopf
    Technician
    • Nov 2021
    • 15

    #31
    Re: XP PageWide Pro MFP 477dw error 0xc6fd0002

    [QUOTE = DRichard; 1999311] ... и это ваша защита ??? Я не видел абсолютно ничего в ваших сообщениях, которые заставили бы меня поверить в то, что вы человек, достойный дальнейшего внимания или поддержки. Желаю счастливого отдыха в твоей жизни. До свидания. [/ QUOTE]


    Then, respected expert, answer me one question: where is at least one message with an answer on the merits of my question? Or the answer: is it time to replace the printhead is this essentially an answer? Or another answer: You cannot get the printhead repaired. You must replace. If your competence is only enough to replace an entire unit, then you cannot be considered a specialist, since this is not a repair or restoration of the device's functionality. Any birdie can cope with the task of replacing a complete unit in 20 minutes, but what then is the repair? Or does it all work for you?


    Тогда уважаемый эксперт ответь мне на один вопрос: где хоть одино сообщение с ответом по существу моего вопроса? Или ответ: пора заменить печатающую головку это ответ по существу? Или еще один ответ: Вы не можете отремонтировать печатающую головку. Вы должны заменить. Если вашей компетенции хватает только на замену целого узла значит вы не можете считаться специалистом так как это не ремонт и не восстановление работоспособности устройства. Любой птушник справиться с задачей по замене полного агрегата за 20 минут, но в чем тогда заключается ремонт? Или у вас все так работают?

    Comment

    • tmw
      Trusted Tech

      250+ Posts
      • Dec 2013
      • 256

      #32
      Re: XP PageWide Pro MFP 477dw error 0xc6fd0002

      Unfortunately, HP doesn't make these heads possible to repair. It would involve chips that aren't made available, or to replace failed stacks that would be impossible outside the factory. It's not worth it to them to do it inside the factory either. The head is priced to expensive. And to remove and replace it is a major operation that wouldn't be worth your time. There is a manual explaining how to do it. I think you would decide it wouldn't be efficient either.

      Comment

      Working...