I have the manual
I replaced the fuser drive assembly and now get the error 57.07.
The fan 3 is turning fine when I turn on the printer (both fan under the cartridges turning fine).
The connector J262 is connected properly on the High voltage supply board.
The J114 is connected properly on the DC control board.
Any idea?
Thanks
I replaced the fuser drive assembly and now get the error 57.07.
The fan 3 is turning fine when I turn on the printer (both fan under the cartridges turning fine).
The connector J262 is connected properly on the High voltage supply board.
The J114 is connected properly on the DC control board.
Any idea?
Thanks