No op-panel display.HOWEVER-When I take the top cover (with same op panel attached) & install it on a different printer (same model), it works correctly, so I know the op-panel assembly is ok. What should I check next? Thanks for your time & help. J Sasser,
-
-
Was the memory or firmware removed from the formatter? If the memory & firmware are good, then the formatter is bad.Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one hand - chocolate in the other - body thoroughly used up, totally worn out and screaming "WOO-HOO, what a ride!". -
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.comComment
-
Paul, I will let you know if I decide to buy a service manual on anything. I dont have any credit so you dont need to generate an e-mail for me every time I post a question. Thankyou for your servive J Sasser,Comment
-
Have you tried the formatter in the other unit? Re-seat all connections on the DC cont.Comment
-
SIR, I dont know what a formatter is -where its located or even what it looks like. Can I have a clue PLEASE?Comment
-
formatter is the main board of the printer. kinda like the mother board. heres the part # HP C7096-69006Comment
-
It's the board you plug the parallel cable, firmware and memory DIMM's go into as well. If you are not a tech, I would advise getting one at this point.Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one hand - chocolate in the other - body thoroughly used up, totally worn out and screaming "WOO-HOO, what a ride!".Comment
-
ok thanks,Comment
-
ok thanks friend,Comment
Comment