If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It's not going to be a sensor flag. You will need to replace the cartridge lock kit for all 4 cartridges (even though you may only have a broken one for the black cartridge). It involves gear timing and is fairly involved. Don't attempt this without a manual or if you are not a tech. Yes, I do have instructions. Do you need an MP tray or just a sensor flag for it? Your best resource for manuals is manuals4you.com. It's what the rest of us use and although I would like to help you more, I see a red flag under your name. Most of us don't like people asking for free service manuals or firmware. Free help is another story, but it is most appreciated when the person asking for help also contributes help to their fellow technicians, too.
Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one hand - chocolate in the other - body thoroughly used up, totally worn out and screaming "WOO-HOO, what a ride!".
It's not going to be a sensor flag. You will need to replace the cartridge lock kit for all 4 cartridges (even though you may only have a broken one for the black cartridge). It involves gear timing and is fairly involved. Don't attempt this without a manual or if you are not a tech. Yes, I do have instructions. Do you need an MP tray or just a sensor flag for it? Your best resource for manuals is manuals4you.com. It's what the rest of us use and although I would like to help you more, I see a red flag under your name. Most of us don't like people asking for free service manuals or firmware. Free help is another story, but it is most appreciated when the person asking for help also contributes help to their fellow technicians, too.
I do help others when I can, often times I dont have time to check the site unless I am looking for something, like today. Also, when I do check the posts, I really dont like to respond unless I know for sure what I am talking about, why waste time for the other guy? Anyway, I need the trays for the MP as the customer has broken them off. I didnt want to purchase a manual, not being cheap but the fact is we do not do very much with HP machines at all, primarily Toshiba and Copystar. Any help you can give is greatly appreciated, but if not, I understand as I do not give manuals out readily either. With Toshiba and Copystar the manuals are given to anyone certified so anyone asking for them is typically not... As for HP, we have begun working with them via our Toshiba contract but have not been "certified" on them.
Need manuals if possible, however, I need to find part numbers for the sensor flag for the black cartridge as well as the MP tray assembly... ??
Just to clarify the flag that I am looking for... it is on the LEFT side of the machine, spring loaded and has a whole on the end of it that lines up with the LED on the board. I have the spring, but the arm itself was broken in half. The MP tray needed is the door assemblies, the customer broke the pin connections so both pieces need replaced.
Comment