[Jamming] HP 3000 sheet staple stacker jogger issue

[Guest]

When making prints or diagnostics sheets sent to the lower bin the front jogger doesn't go to the proper spot so the papers get stuck behind it. I thought the railing needed some triflow oil but it still doing the same thing. I am thinking it the Accumulator Unit or the Finisher Controller Board. has anyone seen this issue before?

[JustManuals]

Re: HP 3000 sheet staple stacker jogger issue

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[Iowatech]

Re: HP 3000 sheet staple stacker jogger issue

Sounds like that machine might be printing on some bad paper. There might be too much change in the paper's moisture content, which will cause the paper to not lay flat enough for the finisher to work properly.
That's just a guess, though.

[Wild Bill]

Re: HP 3000 sheet staple stacker jogger issue

Im going to throw out a guess... Do the gates that switch where the paper goes have solenoids? If so maybe its like the feed solenoids and the foam is old and sticky.
Possible that a clutch assembly or home position sensor is bad; then look at controller pwb; My best guess

[ucinn]

Re: HP 3000 sheet staple stacker jogger issue

When making prints or diagnostics sheets sent to the lower bin the front jogger doesn't go to the proper spot so the papers get stuck behind it. I thought the railing needed some triflow oil but it still doing the same thing. I am thinking it the Accumulator Unit or the Finisher Controller Board. has anyone seen this issue before?

Sounds like the accumulator unit to me.