Hi Guys, i normally find myself in the Sharp Forums but as our company has taken on some HP kit i need your help. I'm sorry if this sounds stupid, but we have installed an M9040 MFP without a finisher; it just has an output tray. However, when we copy a 2 page document, the copied page (ie page 1) lands on the output tray, face up, followed by page 2, face up; so when you pick up the copied document page 2 is facing you with page one behind it. I have searched through all settings for something relating to copy output but cannot find anything. I have seen something similar in Ricoh's over the years, but they would have a "Face up/Face down" output option. Again, apologies if this is stupid, but we've just started bathing our feet in these machines.
-
-
Re: M9040 MFP
Need to set it for face down output which is Standard output
In configure device menu;
PAPER DESTINATION= STANDARD OUTPUT
STANDARD OUTPUT
LEFT OUTPUT BIN
STANDARD TOP BIN
Allows the user to configure the output bin destination.
Only the installed bins appear on the menuIzzy -
Re: M9040 MFP
Oh and I would take the exit tray off
IzzyComment
-
Re: M9040 MFP
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comComment
-
Re: M9040 MFP
Thanks Wild Bill, but this unit will not have a finisher attached - it will onlt have an output tray. Are the settings you refer to available without a finisher installed?Comment
Comment