HP CP4025 Error 59.F0

[berni911]

Hi,

I have a HP CP4025 with Error 59.F0 after 40 - 50 Pages.

I have chagend the fuser and the transfer belt without succsess.

I have run the diagnostic menu without problem...

thanks a lot

br

[Luther]

Re: HP CP4025 Error 59.F0

59.F0 ERROR Transfer alienation failure
1. Verify that the ITB is installed.
2. Reconnect the primary-transfer
disengagement sensor J19, and
connector J128 on the DC controller
PCA .
3. Run the sensor test in the sensor
monitor mode to verify that the primary
transfer disengagement sensor is
functioning properly. If not, replace the
primary transfer disengagement sensor.
4. Perform the alienation drive component
test in the DIAGNOSTICS menu. If not,
replace the fuser motor. See Fuser
motor on page 200.

[berni911]

Re: HP CP4025 Error 59.F0

Hi Luther,

thanks for your help!

Please can you send me a pic where J19 and J128 are located?

Thanks a lot

59.F0 ERROR Transfer alienation failure
1. Verify that the ITB is installed.
2. Reconnect the primary-transfer
disengagement sensor J19, and
connector J128 on the DC controller
PCA .
3. Run the sensor test in the sensor
monitor mode to verify that the primary
transfer disengagement sensor is
functioning properly. If not, replace the
primary transfer disengagement sensor.
4. Perform the alienation drive component
test in the DIAGNOSTICS menu. If not,
replace the fuser motor. See Fuser
motor on page 200.

[JustManuals]

Re: HP CP4025 Error 59.F0

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com