Hello all,
I've got a Laserjet 8000 with a 1/4 inch thick line that is perpendicular to the process path about 1/2 way down the page on 8.5x11 pages. It shows up on side 1 of a 2 sided document. The line does not show if you stop the printer after side 1 has been printed, but only after the duplex process has finished. Both power supplies, the toner cartridge, and the transfer roller assy have been replaced. When doing any single sided jobs the printer runs fine. Anybody have any ideas???
I've got a Laserjet 8000 with a 1/4 inch thick line that is perpendicular to the process path about 1/2 way down the page on 8.5x11 pages. It shows up on side 1 of a 2 sided document. The line does not show if you stop the printer after side 1 has been printed, but only after the duplex process has finished. Both power supplies, the toner cartridge, and the transfer roller assy have been replaced. When doing any single sided jobs the printer runs fine. Anybody have any ideas???