If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have not seen this machine yet, I thought I would ask about this
problem first and may be save some time on the call.
Thanks
DR
Probably cartridge lock/s are broken. Usually it is the right side, but I've seen it be left or even the linking rods/levers (links ETB to the cartridge locks) on either side.
In either case, it is an involved repair if it is the locks (preferably in shop if it is your first time) and you need to replace all 4, even if it is only 1 that is bad. The linking rods/levers can be replaced in field. I would say this is a technician only repair, the left side is intermediate level due to lining up gears on the gear drive and installation of gear drive that is critical. (Observe ESD handling on the boards. Right side has a lot of connectors. Left side requires HVPS removal.)
TSAworld sells the kits for the cartridge locks:
K6633 Left side
K6640 Right side w/instructions & troubleshooting guide
Linking rods and levers:
RC1-6643 Lever, Lock, RGT
RC1-6645 Cam, Slide RGT
RC1-6646 Rod, Link RGT
Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one hand - chocolate in the other - body thoroughly used up, totally worn out and screaming "WOO-HOO, what a ride!".
Comment