placed about 20 lexmark C748 in different location (librarys ) and noticed about 4 are doing this.I have replaced the fuser unit and tried different paper.This doesnt do it all the time.these are brand new printers.called lexmark to open a service ticket.they told me to try to lower the fuser temp,and update the firmware.any ideas?thanks for any imput.
-
-
Re: lexmark C748 void and creasing
This Parts & Service Manual can now be purchased for $14.77 and downloaded immediately from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com -
Re: lexmark C748 void and creasing
I have the manual Lexmark will not talk to you if you are not a dealerComment
-
Re: lexmark C748 void and creasing
What have you tried so far?Comment
-
Re: lexmark C748 void and creasing
have replaced fuser unit,black drum.I picked one up and going to run test on it.it hasnt done it when i have been there .got a transfer unit might try that next.the odd thing about it out of 20 new boxes.it started when one ,thought it might be cheap paper they were using.replaced it with the paper we use,and they said it does it with the paper i left.now i am getting the same problem with 4 now,it would be nice if it would do it when i run it,to see if i can hear a nosie or something,Comment
-
Re: lexmark C748 void and creasing
That is weird. In the pictures in your initial post it kind of looked like a developer blockage in the doctor blade area in the drum units, but that is less likely since you changed the black drum, and somewhat improbable seeing that the machines work when you are around.
How is the environment the machines are in? It sounds kind of like there might be a humidity problem, maybe condensation on the transfer belt in the morning when they first turn the machine on? That might explain why the machine will not display the problem while you are there, the heat from the fuser will dry out the machine before you get there. I've never seen that on Lexmarks, so take this with a grain of salt. But I have seen it on other machines, so if you can get out to one of those libraries when they start their day you might be able to catch it in action then.Comment
-
Re: lexmark C748 void and creasing
thanks for the reply iowatech.what I did today was to replace all toner units,drums,updated the firmware.i am in Colorado so humidity here is very low.tried different paper and still no go.next is the laser unit.the firmware was downloaded by Lexmark.running out of things to try.lol the printer is in our office now.like I said out of 20 new printers got 4 doing this at different locations.Comment
-
Re: lexmark C748 void and creasing
While I don't think the laser unit will help, as much good as I've been here I'm probably wrong.
Still, here's a longshot you might try first if you have time -
Try putting too much paper into the cassette and see if that causes the problem. The reason for that is if the paper skews too much before the registration rollers it can get wrinkled there, which will cause image deletions something like that (those wrinkles sometimes get ironed flat by the fuser, but not always). And if there is too much paper in the cassette, the paper will skew as it initially feeds into the machine. When the amount of paper in the cassette gets to an acceptable level the problem goes away. Most of the times I've seen that there are jams as well, though. And the print on the paper is skewed as well.
Anyway, sorry I wasn't much help, and good luck.Comment
Comment