Konica 7255

[Synaux]

I have two of these turds that I am going to take to the junk yard.

If anyone needs parts for these tell me soon.

I have one good controller and another that might be good. One almost new toner.
The fuser sections are pretty much trashed, but I have one good upper fuser roller and misc parts.
Got a bunch of other stuff I will be happy to remove sell for cheap (plus shipping).

Will be gone in a week.

[Synaux]

Re: Konica 7255

I have two of these turds that I am going to take to the junk yard.

If anyone needs parts for these tell me soon.

I have one good controller and another that might be good. One almost new toner.
The fuser sections are pretty much trashed, but I have one good upper fuser roller and misc parts.
Got a bunch of other stuff I will be happy to remove sell for cheap (plus shipping).

Will be gone in a week.

I still haven't gotten to these--if anyone needs anything just tell me

[printmaki]

Re: Konica 7255

I still haven't gotten to these--if anyone needs anything just tell me

I'd kill for an IP511 if they come with one (specifically the NIC on the IP511 on our 7155 has died, see this post, so either just the NIC or an entire IP511 would be great).

(This assumes you can just swap out one IP511 for another without it needing a pile of further config).

[Synaux]

Re: Konica 7255

I'd kill for an IP511 if they come with one (specifically the NIC on the IP511 on our 7155 has died, see this post, so either just the NIC or an entire IP511 would be great).

(This assumes you can just swap out one IP511 for another without it needing a pile of further config).

I have 1 good IP511 and another one that might work, but taken apart. I can box them both up and you would have some spare RAM and stuff if needed.
There is a bunch of other stuff here still too.

Anyways, check your PMs I will send you my email and phone number.

[Synaux]

Re: Konica 7255

I sent you an email

[town business center]

Re: Konica 7255

where are they located?

[Synaux]

Re: Konica 7255

where are they located?

Corpus Christi, Texas
And I still have just about everything.

Also, I found 2 bran new Web Units and another roller (forget what it is exactly--I am at home at the moment).

[signguys]

Re: Konica 7255

I need the large door off of the finishing unit if you have it? let me know.

I have two of these turds that I am going to take to the junk yard.

If anyone needs parts for these tell me soon.

I have one good controller and another that might be good. One almost new toner.
The fuser sections are pretty much trashed, but I have one good upper fuser roller and misc parts.
Got a bunch of other stuff I will be happy to remove sell for cheap (plus shipping).

Will be gone in a week.