Sharp Finisher AR-FN2 Manual

[frank@teamgoodyear.com]

Just changed the finisher on an AR-507 from just the exit tray to the AR-FN2 finisher.

Now getting an error message "Call for Service: Code: F1-50"

The error message is referring to an un-recognized finisher.

Where can I download the manual? Any suggestions, setup tips?

[JustManuals]

JustManuals

$11.77 and instant download

[johnbla]

You need to up-grade the machine firmware before it will recognise the FN2..

Also you must remove the final pinch-roller springs in the left door or you will get paper jamming on entry to the FN2

[BODINE]

I am pretty sure the 507 only takes the AR-FN3

[johnbla]

Yup....spot on.....my mistake...the AR505/507 will only wear the FN3

[frank@teamgoodyear.com]

Yup....spot on.....my mistake...the AR505/507 will only wear the FN3

Thanks,

I just called my supplier...I got the answer: "Humm....You're right"

The AR-FN2 is for the AR-287/337/407. I need a AR-FN3 for the AR-507