224 dead display

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • kyoceran
    Trusted Tech
    • Jul 2007
    • 100
    #1

    224 dead display

    i'm now struggling to get a resolution to this, have replace ops panel cable, and the flat interface cable between the mfsb and the print controller pc, I would suspect many of you are well versed in the repair of this type of equipment and I would welcome any area to focus on, many thanks in advance
    Tags: None
    • copier tech
      Field Supervisor

      5,000+ Posts
      • Jan 2014
      • 8105
      #2
      Re: 224 dead display

      When you restart the MFP can you hear it warm up/make the usual sounds etc? also can you open PageScope ?
      Let us eat, drink, and be merry, because tomorrow we may die!

      For all your firmware & service manual needs please visit us at:

      www.copierfirmware.co.uk - www.printerfirmware.co.uk
      ​

        Comment

        • kyoceran
          Trusted Tech
          • Jul 2007
          • 100
          #3
          Re: 224 dead display

          the fuser warms up and it keeps turning over, but I am not aware of pagescope

            Comment

            • EarthKmTech
              Step aside, noob

              1,000+ Posts
              • May 2009
              • 2139
              #4
              Re: 224 dead display

              Originally posted by kyoceran
              the fuser warms up and it keeps turning over, but I am not aware of pagescope
              no ilumination of panel or buttons on powerup and engine is making noises is usually fried ram.

              If it starts working again, but then fries the ram again shortly after, replace the mfp board as well as new ram - had this before too.

                Comment

                • copier tech
                  Field Supervisor

                  5,000+ Posts
                  • Jan 2014
                  • 8105
                  #5
                  Re: 224 dead display

                  Yes if the machine is on constant rotation & you cant print or open PageScope (type the ip address of printer into you browser) then you'll be looking at a number of posible causes, the panel NOT one of them.

                  If however the machine will print etc & the warm up rotation stops as normal them it could just be a panel issue.
                  Let us eat, drink, and be merry, because tomorrow we may die!

                  For all your firmware & service manual needs please visit us at:

                  www.copierfirmware.co.uk - www.printerfirmware.co.uk
                  ​

                    Comment

                    Previous template Next
                    Working...