Bizhub c227 new firmware- which bit should be turn on

[cyta123]

In a new firmware for Bizhub c227 was made a modification becouse of streaks on the transfer belt surface. Theres is a n information:
>>KMI has release a Special FW (based on MR3.3) includes "Filming suppressing function" for individual cases.
Engine FW DipSW No. 27: 0=OFF (default), 1=ON <<

But which bit should be turn on, does any one know?

[B0265]

Re: Bizhub c227 new firmware- which bit should be turn on

A Engine FW DipSW can only be set to off or on.

[copier tech]

Re: Bizhub c227 new firmware- which bit should be turn on

Turn it on if your have this issue, if not leave it off.

[cyta123]

Re: Bizhub c227 new firmware- which bit should be turn on

Thx. I will check it tomorrow.

[cyta123]

Re: Bizhub c227 new firmware- which bit should be turn on

I have just found Engine FW DipSW. THX

[copier tech]

Re: Bizhub c227 new firmware- which bit should be turn on

I have just found Engine FW DipSW. THX

Please share to benefit others :0)

[cyta123]

Re: Bizhub c227 new firmware- which bit should be turn on

Service mode => Security mode=> Engine FW DipSW