PDA

View Full Version : Jamming bizhub c754e


Custom Search


NEOTECH
02-13-2019, 07:53 PM
hi dear i have problem for c754e jamming j30-03 as per manual i change PS38-PS39-PS40 but still same and i also change PRCB and PFTDB but can not solve problem
if any one face this problem plz help me (copier still new only 5080 pages print).

antone
02-13-2019, 09:18 PM
Check M2 registration motor in I/O mode...

Sent from my SM-N950U using Tapatalk

blackcat4866
02-14-2019, 03:05 AM
Check that the timing belt hasn't walked off the side of the duplex motor at the top right of the door. =^..^=

rrrohan
02-14-2019, 04:30 AM
Check that the timing belt hasn't walked off the side of the duplex motor at the top right of the door. =^..^=

yeah I have had one like that at runup

antone
02-14-2019, 01:52 PM
Black ya..that happened 2 me

Sent from my SM-N950U using Tapatalk

mincopier
02-14-2019, 02:33 PM
Don't remember if it was this model or this code or not. There is a clutch that the service manual does not mention. It drives the roller after the fuser for the duplex/fuser exit. The wires were barely connected from the factory so it would work then quit, sometimes for several hundred copies.

Custom Search