Konica Minolta bizhub 754e C3101 !

[rvptor]

This is the machine above. I changed the main board, fuser, rear arm, transfer belt, it still throws out the same code. A colleague tried to reset the machine to the factory ones but that didn't solve the problem either ..... If anyone has met before, thanks in advance: D

[jwai]

Re: Konica Minolta bizhub 754e C3101 !

This is the machine above. I changed the main board, fuser, rear arm, transfer belt, it still throws out the same code. A colleague tried to reset the machine to the factory ones but that didn't solve the problem either ..... If anyone has met before, thanks in advance: D

Try the fusing roller separation motor and/or relative parts?

[CompyTech]

Re: Konica Minolta bizhub 754e C3101 !

There's a plastic bushing that sits on the drive shaft of the M29 that cracks. Design was changed to a brass bushing. Might be better off replacing the fuser drive assy.

[rvptor]

Re: Konica Minolta bizhub 754e C3101 !

There's a plastic bushing that sits on the drive shaft of the M29 that cracks. Design was changed to a brass bushing. Might be better off replacing the fuser drive assy.

Thanks for your response...I forgot to mention that i already implement fuser drive assembly as well...
fuserassy.jpg

[Bix]

Re: Konica Minolta bizhub 754e C3101 !

Hello, the manual also indicates the replacement of the PRCB