Konica Minolta C350 RESETTING FUSE PROBLEM

[arriva1]

I was wondering on the Konica Minolta Bizhub C350 if the copier isn't asking for the transfer belt can the fuse still be reset?? Because i tried resetting it with a .315 and 1/2 amp fuse and it won't reset---any suggestions??

[simplex]

I would suspect those fuse ratings are too high. I usually use either 50mA or preferably 80mA.
You can definitely reset part way into service life, I often do this to save return calls.

[arriva1]

Do you know where I might be able to find that 50MA or 80MA fuse?

[simplex]

Here in the UK, I order them from CPC Farnell, or Maplin.
I'm not sure what component suppliers you have in the states, but it should be 50 - 80mA quick blow glass cartridge.

Come to think about it, Katun may sell them, as they are used in a lot of toner cartridges, & they sell the reman. kits.

Hope this helps.

[DadO]

I used 100ma or 0.1A and it worked but if u find something lower then 100ma, use it since 100ma is on edge

[Bizhub]

Don't fit to high a rating fuse as you will damage the PWB MC.
80ma glass fuse's are everywhere but try RS in the states
Good Luck

[pepper38_cnd]

The OEM fuse is 1/16 A or 62Ma I use 63Ma as for some reason they are about 1/4 the price of 62Ma. But the advice you have been given is correct too high a rating is very risky ( board damage can occur ). I can supply you the 63Ma fuses if you need them.