If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hey everybody. Got a BizHub Pro C6500 with a C-2211 code at start up. & a C-500 with a C-2701. What are those codes ? Thanks
BizHub c6500:
When the drum motor/Y (M14)
was ON, M14 abnormality
detection signal was continuously
detected for the specified
time.
Main body
stops immediately
and main
relay (RY1) is
turned OFF.
Printer control board (PRCB)
The 2211 code sounds like a flipped clean blade on the yellow. There has been a lot of cases of this, and the result is a new type of drum. Different surface and more steep angle on the blade.
Just like the "good olde days" on the Kyocera FS3500
Comment