Oce CS665 // KM C6501 Long Paper Softswitch

[resolute]

Can someone give me the detailed softswitch dipswitch setting to enable long paper mode (ie. 1200mm//47.25"). My service tech can't seem to get that info.

[Si@danwood]

Not a 100% sure there is one

[random]

I only know of a patch for the Creo, it hasn't been marketed by us so maybe it's a myth.

[sbillis]

Can someone give me the detailed softswitch dipswitch setting to enable long paper mode (ie. 1200mm//47.25"). My service tech can't seem to get that info.

you can do that but I don't have that info now.

you can send for print 1200mm one by one (<600mm up to 10 >600mm one at a time)

be patient please.

[sbillis]

try dipsw 10-0-0, 10-1-0

[Si@danwood]

try dipsw 10-0-0, 10-1-0

why would disabling the hard disk image enable banner mode?

[prakashshetty_thane]

Can someone give me the detailed softswitch dipswitch setting to enable long paper mode (ie. 1200mm//47.25"). My service tech can't seem to get that info.

Try and change DIPP SW setting 10-0-0 to 10-0-1 to enable banner mode.
Bypass tray is a must and U can feed only 1 paper at a time and cannot feed another paper unless the first paper has exited the m/c.
Time consuming but effective..

No need to disable the HDD.

[seniortech]

These are the settings you need for Banner printing:

Set DIP-SW 10-0 to 1
Set DIP-SW 10-1 to 0

Paper is fed via bypass, I have two of these machines that are only used for banner printing, works well without problems.