Konica 7165 error code 49-04

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Machinercylr
    Technician
    50+ Posts
    • Dec 2006
    • 73

    Konica 7165 error code 49-04

    Looked in intravia's manual and found nothing remotely close to it. What can be the probable cause?
  • njkid
    Junior Member
    • May 2009
    • 6

    #2
    Possible hard drive failure in IP-511. If hard drive is ok, writing system code back onto hard drive should correct issue.

    Comment

    • minimerlin
      Senior Tech
      Site Contributor
      500+ Posts
      • Nov 2007
      • 851

      #3
      Yep, problem with controller, sometimes the unit just needs to cool down and then works ok. Is the machine hard against the wall..it needs vent space for the controller. If code comes back you will need a new drive.
      Please do not PM me without asking first.

      Comment

      • Machinercylr
        Technician
        50+ Posts
        • Dec 2006
        • 73

        #4
        Originally posted by minimerlin
        Yep, problem with controller, sometimes the unit just needs to cool down and then works ok. Is the machine hard against the wall..it needs vent space for the controller. If code comes back you will need a new drive.
        I will try this......Copier is up against the wall,And have informed the user what might be expected f this does not clear-up this,...Thanks for the wonderful info....Best Regards,Steve

        Comment

        • remati
          Trusted Tech
          100+ Posts
          • Apr 2010
          • 149

          #5
          ..look at the fan if it is work well and if it is clean...
          ..the fan of the IP,of course

          Comment

          • Machinercylr
            Technician
            50+ Posts
            • Dec 2006
            • 73

            #6
            Scheduled unit for cleaning of fans

            Originally posted by remati
            ..look at the fan if it is work well and if it is clean...
            ..the fan of the IP,of course
            It has been a awhile since the back shroud has been pulled, I was thinking of this last Friday, ....A little P.M..Thanks for all that has acknowledged my Thread......Steve

            Comment

            Working...