Di 7210 SC21-05 ?? can't find

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Sam Tofu
    Trusted Tech

    Site Contributor
    100+ Posts
    • Dec 2007
    • 130
    #1

    [Error Code] Di 7210 SC21-05 ?? can't find

    Can't find this code.
    All SC's in Field guide have to do with finisher.
    Yet saw a post on a SC21-01 being a charge error.
    What's the -05
    Thanks in advance
    Tags: 210, 721, 7210, charge, code, error, field, finisher, guide, mrwho, sc2, sea, stuck
    • rocky246
      Technician

      50+ Posts
      • Feb 2007
      • 91
      #2
      Could it be an F21-05 fault?

        Comment

        • Sam Tofu
          Trusted Tech

          Site Contributor
          100+ Posts
          • Dec 2007
          • 130
          #3
          Thanks Rocky, I'll check that out. What is confusing is in the Field S.M. under error codes -there are a number of SC codes relating to finisher. yet none close to 21-05.

          I'll take a look tomorrow at the tran/sep area and the cleaning motor for them

          Happy Thanksgiving

            Comment

            • mrwho
              Major Asshole!

              Site Contributor
              2,500+ Posts
              • Apr 2009
              • 4303
              #4
              That error usualy relates to the cleaning of the transfer-separation corona. Check the corona for binding (I had one where those plastic guides were badly seated and the cleaning unit would be stuck on them). You can also return the cleaning unit by hand and then disable the cleaning function for that corona by changing software switch 3-4 to 1.
              ' "But the salesman said . . ." The salesman's an asshole!'
              Mascan42

              'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
              Ibid

              I'm just an ex-tech lurking around and spreading disinformation!

                Comment

                • Sam Tofu
                  Trusted Tech

                  Site Contributor
                  100+ Posts
                  • Dec 2007
                  • 130
                  #5
                  Thanks mrwho, will check it out

                    Comment

                    • Sam Tofu
                      Trusted Tech

                      Site Contributor
                      100+ Posts
                      • Dec 2007
                      • 130
                      #6
                      Was DV dumping on trans/sep. Cleaned DV unit, Drum (toner catch plate etc.) turned off trans/sep clean motor. Still dumping DV and toner. towards the rear (within 15 copies got really bad again.

                      New customer, copier was moved. But properly prepped. Checked DV anyway was not binding -all leveled out. Meter is 525K. DV was replaced at 500K. Drum not replaced.

                      Not certain what is causing the dv/toner dump.

                        Comment

                        Previous template Next
                        Working...