Hi all and thank you for the reply.
I'm back from the customer of this thread
http://www.copytechnet.com/forums/konica-minolta/56354-bizhub-420-c-2403-c-6701-a.html
Replaced PS28 (again) and OACB.
The error codes went away, but there is still another problem.
Every page is jamming at the registration section, no matter of the drawer.
Changed the reg. section (entirely) with another one that i'm sure is working, still jamming.
Loaded service mode, state confirmation, load check.
Code 21 Multicode 11: ok but the reg. roller is not moving.
Code 26 Multicode 1 - 2 - 3 no action at all.
Any ideas?
I'm back from the customer of this thread
http://www.copytechnet.com/forums/konica-minolta/56354-bizhub-420-c-2403-c-6701-a.html
Replaced PS28 (again) and OACB.
The error codes went away, but there is still another problem.
Every page is jamming at the registration section, no matter of the drawer.
Changed the reg. section (entirely) with another one that i'm sure is working, still jamming.
Loaded service mode, state confirmation, load check.
Code 21 Multicode 11: ok but the reg. roller is not moving.
Code 26 Multicode 1 - 2 - 3 no action at all.
Any ideas?
Comment