customer has DI3510, stays in warm up screen ( illustrations of 4 or 5 copiers ). attempted reboot, trouble reset; occasionally system goes to ready and becomes operational - 10% operational, 90% inoperational. Eventualy goes back to 'initial start up' screen and freezes up. Used as their printer - possible computer system issue ? Could use some help with this one
-
-
Re: Konica Minolta DI3510
I would remove the network cable from the device and see if the machine goes to the ready state. I had one where the nic went bad and would make the machine reboot, but once i disconnected the network cable it would copy fine. -
Re: Konica Minolta DI3510
Try disconnecting HDD. I had the same problem and that is what it was.Comment
-
Re: Konica Minolta DI3510
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comComment
-
Re: Konica Minolta DI3510
Check power as well, also might need a flash.Color is not 4 times harder... it's 65,000 times harder.
They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.Comment
-
Re: Konica Minolta DI3510
try remove the NC4 scan unit card and see. if still error rewrite firmware .
Comment
Comment