Bizhub scanner/ADF out of alignment?

[ECA]

Hi guys

Another question, for the Bizhub C552.
ive noticed the ADF scans/copies with some wrapping/bluring on the pages.
im assuming this is due to the ADF cover is not correctly aligned. or there is a gap.?

I need to know if i need to adjust the hinges of the ADF top?

When the top is shut it has a 1cm gap at the back where the hinges are.. but the front is flush. see picture of what i mean...

http://i61.tinypic.com/9sf1gy.jpg

Is this correct?

also is the top lid fully in line with the bottom of the printer? as it seems offset... aka the footprint is flush with the printer casing below..

[habik]

Re: Bizhub scanner/ADF out of alignment?

Hope this helps.

ADF height adjust.jpg

[ECA]

Re: Bizhub scanner/ADF out of alignment?

Hope this helps.

[ATTACH=CONFIG]27653[/ATTACH]

Thx can u upload again? Its just blurred image

So im guessing it needs to be flat on glass??

[habik]

Re: Bizhub scanner/ADF out of alignment?

ADF height adjust.jpg

Hope this helps.

[ATTACH=CONFIG]27653[/ATTACH]

[allan]

Re: Bizhub scanner/ADF out of alignment?

use a piece of paper 1 inch wide folded four times. Put that at both sides front and rear of slit glass, it must pull out with the same amount of tension then the DF would be perfect.

[ECA]

Re: Bizhub scanner/ADF out of alignment?

thanks all. sorted. must of moved when getting the beast up stairs to the forth floor!!

[Northwestservice]

Re: Bizhub scanner/ADF out of alignment?

that interesting because i was going to ask what has been done for the df to be out of postion