Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    Technician Phill.Harden's Avatar
    Join Date
    Aug 2007
    Melbourne Vic
    Rep Power

    NVRam Service/CE Code

    Hi everyone

    I have 3 low volume Di2510s which I have just discovered have a unique service password set.

    I cannot obtain this password from the wholesaler who supplied them.

    I am not directly connected to the local Konica Minolta distribution channel within Australia and can not obtain exchange nvram units.

    Phase2 service manual says if code is forgotten then PWB-A will have to be replaced.

    Is someone aware if the service code is retained in the 1K EEPROM IC3 plugged into PEB-A

    Without obvious options I am inclined to dump the memory in the ROM board and attempt to force a full initialise, but I don't know if this will lock up the machine.

    Possibly others have been in this same position and can offer advice or a pointer or two.

    Thanks... Phill

  2. #2
    Field Supervisor 1,000+ Posts RRodgers's Avatar
    Join Date
    Jun 2009
    San Bernardino
    Rep Power
    What I remember from school is if you forget the CE password yep you are going to have to replace the board. (or was it NVram?) uggg it's been years. I would think the code is held in the NVram. A full wipe might help but yeah, it can be a pain to reset the machine back up again. Course, if you change the NVram you are going to have to do that anyways.
    Good luck.
    Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=

IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here