Ricoh MPC307 SC672-00

[halloman56]

[Hoosierdaddy]

Re: Ricoh MPC307 SC672-00

Its the Control Board Needs Repaired or Replaced

[slimslob]

Re: Ricoh MPC307 SC672-00

Does it have the Extended USB card installed? If so, I found the following in the Cxx04 manual.

Before installing this option, disable (Set to 0: OFF) the STR shift function by SP5-191-001 (Power Str Set). If installing without disable the STR shift function, SC672-00/ SC672-11 may occur.

[sandmanmac]

Re: Ricoh MPC307 SC672-00

i noticed on controller board an mini-usb slot that might be helpful for log data or FW update, by any chance is there any tools for that maybe? Thanks in advance.

Huh???
F/W update is done using the sd card spot on the side of the machine as it always has been

[copier tech]

Re: Ricoh MPC307 SC672-00


As rule of thumb try & update the firmware via SD card, if the machine won't accept this & throws SC672 then you need to replace the controller board.

If however the firmware updates successfully this may resolve the error.

[ridgemill]

Re: Ricoh MPC307 SC672-00

but i noticed on controller board an mini-usb slot that might be helpful for log data or FW update, by any chance is there any tools for that maybe? Thanks in advance.

Most likely, this is used for writing factory firmware / configuration.

The operations panel firmware is updated if you use the package, or can be done separately using CheetahSystem on an SD card, placed in the side slot of the operations panel.
You will need to enter the Android recovery screen to perform this update.

[halloman56]

Re: Ricoh MPC307 SC672-00

Does it have the Extended USB card installed? If so, I found the following in the Cxx04 manual.

It has only card reader installed but nothing more.

[halloman56]

Re: Ricoh MPC307 SC672-00

As rule of thumb try & update the firmware via SD card, if the machine won't accept this & throws SC672 then you need to replace the controller board.

If however the firmware updates successfully this may resolve the error.

[halloman56]

Re: Ricoh MPC307 SC672-00

Most likely, this is used for writing factory firmware / configuration.

The operations panel firmware is updated if you use the package, or can be done separately using CheetahSystem on an SD card, placed in the side slot of the operations panel.
You will need to enter the Android recovery screen to perform this update.

I might check that out, thanks.

[Pixtech Frameworks]

Re: Ricoh MPC307 SC672-00

Replace main controller board, had issues like this after NV ram check no avail, main controller board replacement solved the problem