[CQ] D95 LD Power(ESD) 1023 NG in Procon,Ligth prints

[SeniorTch]

Hi,
Who Knows where to adjust this value [LD Power (ESD)......Patch 1 660, Patch 2 540, Setup 1023 Target - Measured- ,Result NG

This happens in Procon on and Off, xerox D95,D110,D125

prints are very ligth, replaced Drum Cartrige,

tRANSFER BELT ASSY, Developer Material ESV sensor,, initialized NVM IOT, with no results.
Thanks to everybody for your help

Francisco

[xcopytech]

Re: D95 LD Power(ESD) 1023 NG in Procon,Ligth prints

Clean ros, clean or replace ADC sensor.
Check toner concetration in developer assy.
Procon on print and post here results