I have a xerox 700i and i have the error 010-319 i have already chang the nvram 744-351 to 0 but same problem
-
-
Re: Xerox 700i error 010-319 can anyone help
The 700i edoc says set nvm 744-316 to 0, not 744-315. It states to check fuser heat sensors and fuser drawer connector for bent pins, dirt, or burnout. Then to replace fuser assembly. -
Re: Xerox 700i error 010-319 can anyone help
Procedure
It may be necessary to set NVM [744-361] to 0 in order to clear this failure.
Check that there is no foreign object on the Heat Roll surface and no paper wound around it.
Check the Fuser Sensors are free of dirt.
Check that the Drawer Connectors connecting the Fuser Unit and the main unit are free from bent pins, foreign objects and burnout.
Replace the Fuser Assy ( PL 8.1)Comment
-
Re: Xerox 700i error 010-319 can anyone help
According to fault manual
010-319 Fuser Center Thermistor Differential Amp RAP
WorkCentre 7132Service DocumentationWorkCentre 7132705P01181 (EDOC/SGS)RevisionJanuary 2007
troubleshoot the fusing unit, check the thermistors. and connectors.THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burkeComment
-
Re: Xerox 700i error 010-319 can anyone help
Thanks guys. I think he got the message.Comment
-
Re: Xerox 700i error 010-319 can anyone help
Oh, I knew that, but just wanted to get the feedback. so here is a question. Is there a UI mode for the 700 and 700i and can a tech troubleshoot or test some functions of the machine in this mode.
Just learning about this machine, so be patient.THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burkeComment
Comment