[Jamming] The paper has jammed CANON iR6570/5570

[gensys]

Display mess. >> Open the feeder cover (if any originals are left in the original feeding tray, remove them)

But the paper in Feeder (ADF) is not present

[y_us1982]

initialize the feeder sensor. svc mde>feeder>function>init
hope that solve yr prblm....

Display mess. >> Open the feeder cover (if any originals are left in the original feeding tray, remove them)

But the paper in Feeder (ADF) is not present

[zoraldinho]

Display mess. >> Open the feeder cover (if any originals are left in the original feeding tray, remove them)

But the paper in Feeder (ADF) is not present

tell as jam code.

[gensys]

Hi my friends Zorald
E000014-0000

[gensys]

Thaks!!!!!!!!!!! Y_US1982

[zoraldinho]

Hi my friends Zorald
E000014-0000

Sorry friend but you give me an error for fixing motor.

Check in service mode:

COPIER<DISPLAY< JAM

[mrfixit51]

Hi my friends Zorald
E000014-0000

If this is indeed the error, rebuild the fuser assembly. If turning the green knob on the fuser assembly feels erratic, there are flat spots on the rollers, and this can cause the E014's...

[charm5496]

Display mess. >> Open the feeder cover (if any originals are left in the original feeding tray, remove them)

But the paper in Feeder (ADF) is not present

looks like there are two different issues going on for gensys. There E014 error and the ghost jams in the DADF. Curious if he is getting the remove jam after the machine power is cycled OFF/ON for the error code.

[gensys]

Copier<display< jam

code 0045

[teckat]

Copier<display< jam

code 0045

J0045

Level 1 - FEEDER>FUNCTION>SENS-INT in service mode
adjustment will indicate "OK!" if it ends normally.

[gensys]

Hi <techkat> - my friend

After initialization of sensor controls the error passes but when the mashin reboots or joins - is switched off
again gives out an error 0014 even at disconnected ADF, can??? sets factory defaults may by?
Thanks !!!!!

[teckat]

Hi <techkat> - my friend

After initialization of sensor controls the error passes but when the mashin reboots or joins - is switched off
again gives out an error 0014 even at disconnected ADF, can??? sets factory defaults may by?
Thanks !!!!!

E014 is a Fixing Unit error/check LFR/Fuser roller bearings

also check that the front door switch sitting correct.
Check & Adjust the magnet on the front door to depress the front door switch fully.

door switch not being closed correctly will cut the 24v to fix motor

[gensys]

teck kat my fiend
see

DSC00035.JPG


DSC00036.JPGDSC00037.JPG

Thanks for all

[mrfixit51]

As I previously stated,, the E014's are caused by the fuser, not a Document Feeder. As Teckat and I have stated, look to your fuser area for a solution...

[teckat]

U HAVE A FUSER ISSUE/
Either remove it to inspect-
or ignore it/ it's your choice

Flip a coin= Heads I Win/Tails U Lose

ERROR CODE:
E014-0000 (fixing motor error)
After the fixing motor has gone on, the machine does not detect the phase lock signal for the fixing motor for
2 sec or more.

The PULL lock signal of the fixing motor
does not arrive for 2 sec even when the
fixing motor has been turned on.

- Check the connector for any fault in connection.
- Replace the motor. M3: fixing motor