Working on a km-4800 wide format. Came in on a e-0003 fuser code. Cleared and replaced thermistors on fusing unit. Working fine for 3 days and i am now getting a E-0004 error code Fuser low temp error. I can clear it and it will work but it eventually comes back. Any suggestions.
-
-
Have you checked that all the fans are clear of lint, and running, and pointing in the right direction? Some of the trickiest fuser problems came down to a fan pointed the wrong way, or a clogged filter. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: kyocera-mita 4800w
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Paul@justmanuals.comComment
-
Re: kyocera-mita 4800w
I reset the code yesterday and it is back today. Has anyone resolved this issue.Comment
-
Re: kyocera-mita 4800w
Check to make sure the fuser roller hasn't deformed. I pulled one out that had turned into a slight rainbow shape.The bow shape would cause the thermistor to read incorrectly if the roller stopped with the bow away from the thermistor surface.Comment
-
Re: kyocera-mita 4800w
Thanks, I ordered both thermistors and the interlock switch. I will post a update.Comment
-
Re: kyocera-mita 4800w
I replaced the thermistors. ok so farComment
-
Re: kyocera-mita 4800w
[QUOTE=luis8832;158567]Working on a km-4800 wide format. Came in on a e-0003 fuser code. Cleared and replaced thermistors on fusing unit. Working fine for 3 days and i am now getting a E-0004 error code Fuser low temp error. I can clear it and it will work but it eventually comes back. Any suggestComment
Comment