Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Junior Member Hoss99's Avatar
    Join Date
    Sep 2013
    Location
    Ossian
    Posts
    8
    Rep Power
    0

    Re: Sharp DX-C401 with code L4-16

    The code has to do with the fuser pressure release sensor. Check to make sure the release solenoid is moving as well.


  2. #12
    Trusted Tech 50+ Posts
    Sharp DX-C401 with code L4-16


    Join Date
    Nov 2005
    Posts
    68
    Rep Power
    25

    Re: Sharp DX-C401 with code L4-16

    In addition to all of the above, I have found many fusers where all of these items are fine (& some where techs have replaced some or all of them) & the fuser still frequently fails to pressurize or release, generating the L4-16 code. The ratchet system consists of 2 one way bearings, one in the ratchet arm, & another at the other end of the shaft, If the one in the arm fails, the shaft wont turn, but if the opposite one fails, the shaft will wobble back & forth until the machine times out & throws the code. I just (because I was tired of ordering fusers at far below their yield) pulled several "bad" fusers off of the shelf & ripped into them. I now have a few more "good" ones. Hope this saves some of you a few bucks.


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here