I'm unable to perform the toner curve adjustment without error, either thru sim, or adj maint.
When done thru sim it errors s003, when done thru...
223 results in 0.0479 seconds.
-
Toner curve error ta 5053ci
-
3010i fusing
Fuser rub off.Installed New fuser same issue. Runs 1st page with rub off in center. Firmware up to latest for this model. Checked fuser temps after 5... -
6052CI
I am not getting any magenta at all and i know to push in the gray post for the mag roller, no codes. Replaced mag-developer unit with new, made calibrations... -
steve435 started a topic [CQ] Sharp MX2640 copy test sheet with grays coming out with purplish colorin SharpSharp MX2640 copy test sheet with grays coming out with purplish color
Hi I recalibrated with sim 46-24 & 67-24 but I still get gray coming out as purplish color when copying test... -
How to adjust the development bias on TA 3010
Hello, I have a Taskalpha 3010i that the Bias is of (Slight black glow behind letters). There is no auto adjust on SIM 140 and they provide no instruction... -
Fusing condition ADJ
Hello,
what does the "fusing condition ADJ" in SIM 43-1 mean? -
MX-3071 Touchpad
I have a touchpad that I can't push "execute" on (too low on screen). I can't get into sim mode to get to 65-1. Any ideas? -
Replacing sbc
Hi
I am going to replace sbc pwb for wc7225. I will use board from another machine.
I think I should install old eprom to new sbc.... -
Remote reading of the meter reading
Exists a software for remote reading of the meter reading from Konca Minolta? Sometimes there are machines with the interface using with a sim card. Thanks... -
SHARP MX-M363 Copy Count was reset by new tech and need to fix it.
I had a new tech accidently reset the copy count with sim 24-06 and now when I request meter counts from my customers they are not right. When holding... -
Copystar - Kyocera 1635 just stops
Key in we'll say 30 copy's. Runs a random amount then stops in mid cycle and screen shows "copying" even though no main motor running. No jams... -
-
Sharp mx m654n
Looking for how to get into sim mode , these ones don’t have # .... keys? If finisher is not installed how many prints can land in standard center... -
Doug James started a topic [Error Code] Sharp MX 4141 "Copy prohibited from tray selected. Pls Select another" (Tray 1)in SharpSharp MX 4141 "Copy prohibited from tray selected. Pls Select another" (Tray 1)
Hello, The customer was having jam issues. When I arrived the paper tray 1 has this message: Copy prohibited from tray selected. Pls Select another. I... -
sharp mx3140n
hello
I do mostly toshiba but have been a tech since 1986
im working on an mx3140 that had lines in yellow and cyan so i replaced both drum...
