If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The Segment III and less are rebadges, some Konica Minolta. I'm pretty used to those now.
The faster ones I only know what the Oce' techs used to say: it takes forever to get parts from Japan. And they're built sturdy, like a press.
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
The Segment III and less are rebadges, some Konica Minolta. I'm pretty used to those now.
The faster ones I only know what the Oce' techs used to say: it takes forever to get parts from Japan. And they're built sturdy, like a press.
=^..^=
From what I can see the Seg III and lower have all been dropped by OCE and have been replaced by the Canon iR-Advance equivalent, they and Canon are offering the VarioPrint DP line
I think the Kyocera-Mite guyz should be able to give you some insights into the working of these machines. If I remember correctly oce was trading with KM not many months ago before their 'marriage turned sour', and the had to sell to canon.
Comment