ir2530i

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • akm
    Trusted Tech

    100+ Posts
    • Sep 2012
    • 155

    #1

    [Jamming] ir2530i

    Dear/CopyTechTeam,

    I want your help to solve the problem with canon ir2530i that jammed only when making two sided (duplex) from cassette 1,2 A4,A3 but one sided works good .THE JAM CODE IS 0105 , 0107 . your rapid answer very important i send a picture of jam






    Photo0605[1].jpg
    thanks
    akm
  • Jake2o
    Trusted Tech

    250+ Posts
    • Dec 2007
    • 325

    #2
    Re: ir2530i

    Originally posted by akm
    Dear/CopyTechTeam,

    I want your help to solve the problem with canon ir2530i that jammed only when making two sided (duplex) from cassette 1,2 A4,A3 but one sided works good .THE JAM CODE IS 0105 , 0107 . your rapid answer very important i send a picture of jam






    [ATTACH=CONFIG]30958[/ATTACH]
    thanks
    akm
    Have a look on the top guide. There should be 2 small sticky pads that hold up the guide. When these get work the guide sits too low and jams on duplex but works fine on simplex.

    Comment

    • akm
      Trusted Tech

      100+ Posts
      • Sep 2012
      • 155

      #3
      Re: ir2530i

      Originally posted by Jake2o
      Have a look on the top guide. There should be 2 small sticky pads that hold up the guide. When these get work the guide sits too low and jams on duplex but works fine on simplex.


      thanks jake2o for your answer , i want to know the position of 2 small sticky pads.

      Comment

      • mramlawi
        Senior Tech

        500+ Posts
        • Jul 2011
        • 838

        #4
        Re: ir2530i

        First of all make sure that your papers is not wet,change the papers ,then check if its jaming on a3 or a4r,since a few weeks i faced a problem only in the double side a4 in all casettes the papers prints/copy around 2 documents the. A white paper exit and then jammed it was thr duplex clutch i replace it and now its working in a very good condition .
        Distinguished road makes you jewel in rough

        Comment

        • roho
          Senior Tech

          500+ Posts
          • Mar 2009
          • 844

          #5
          Re: ir2530i

          There is a duplex motor and pcb that drives it. I've had a few back when they first come out that had the exact same issue, duplex jamming and working great simplex. The motor and pcb fix the issue.

          Comment

          • copier tech
            Field Supervisor

            5,000+ Posts
            • Jan 2014
            • 8132

            #6
            Re: ir2530i

            Does it jam every time on duplex or will some 2nd side copies pass ok?

            If the fault is intermittent open a new pack of paper & try that, b/w Canon's have never been good at feeding damp or poor quality paper when running duplex.
            Let us eat, drink, and be merry, because tomorrow we may die!

            For all your firmware & service manual needs please visit us at:

            www.copierfirmware.co.uk - www.printerfirmware.co.uk

            Comment

            • Jake2o
              Trusted Tech

              250+ Posts
              • Dec 2007
              • 325

              #7
              Re: ir2530i

              In you picture it is the guide that is at the top of the picture the top side of the paper. There are 2 bits of plastic that stick out, one on each end, and underneath them they have a bit of sponge this wears out over time and this can cause this fault.
              Canon have a part number for this bit of felt, but any kind of one sided sticky felt or sponge will do the job.

              Comment

              • akm
                Trusted Tech

                100+ Posts
                • Sep 2012
                • 155

                #8
                Re: ir2530i

                Originally posted by copier tech
                Does it jam every time on duplex or will some 2nd side copies pass ok?

                If the fault is intermittent open a new pack of paper & try that, b/w Canon's have never been good at feeding damp or poor quality paper when running duplex.

                first it passes 2nd side copies after that the m/c makes jam


                akm

                Comment

                • akm
                  Trusted Tech

                  100+ Posts
                  • Sep 2012
                  • 155

                  #9
                  Re: ir2530i

                  Originally posted by mramlawi
                  First of all make sure that your papers is not wet,change the papers ,then check if its jaming on a3 or a4r,since a few weeks i faced a problem only in the double side a4 in all casettes the papers prints/copy around 2 documents the. A white paper exit and then jammed it was thr duplex clutch i replace it and now its working in a very good condition .

                  i changed the duplex clutch with stackbypass clutch and the machine works good . thanks for your help

                  Comment

                  • mramlawi
                    Senior Tech

                    500+ Posts
                    • Jul 2011
                    • 838

                    #10
                    Re: ir2530i

                    u always welcome
                    Distinguished road makes you jewel in rough

                    Comment

                    • akm
                      Trusted Tech

                      100+ Posts
                      • Sep 2012
                      • 155

                      #11
                      Re: ir2530i

                      Originally posted by mramlawi
                      u always welcome

                      thanks
                      akm

                      Comment

                      Working...