1025IF Rebooting

[Brian8506]

Reboots every 3 minutes. Power light stays on. Replaced ddr, flash drive, network board, and board that network board plugs in to. Assuming that is main controller. Any help would be appreciated

[mosey1100]

Re: 1025IF Rebooting

Reboots every 3 minutes. Power light stays on. Replaced ddr, flash drive, network board, and board that network board plugs in to. Assuming that is main controller. Any help would be appreciated

This is what I found on your issue. Have you tried reseating the DDR Memory?

[Brian8506]

Re: 1025IF Rebooting

Yes. And switched from another machine


Sent from my iPhone using Tapatalk

[teckat]

Re: 1025IF Rebooting

Yes. And switched from another machine


Sent from my iPhone using Tapatalk

Suggestion !
Pull out the Optional PCL Printer Kit-AB1 if installed, then restart.

Image Processor PCB May be last resort.

[Brian8506]

Re: 1025IF Rebooting

Not sure where that kit is but it doesn't show up on options on user data report. Already changed ip board. It reboots exactly 3 min 10 sec after display comes on


Sent from my iPhone using Tapatalk

[zoraldinho]

Re: 1025IF Rebooting

Power supply or DC controller PCB?

Also Fax NCU or fax modem can be bad.

[Brian8506]

Re: 1025IF Rebooting

Replaced nuclear and fax modem this morning. Haven't tried power supply because it only reboots. Green power light stays on. Isn't the ip board the school controller? No other boards back there


Sent from my iPhone using Tapatalk

[zoraldinho]

Re: 1025IF Rebooting

[Brian8506]

Re: 1025IF Rebooting

That was ncu. Damn spell check


Sent from my iPhone using Tapatalk

[zoraldinho]

Re: 1025IF Rebooting

That was ncu. Damn spell check


Sent from my iPhone using Tapatalk

NCU


index.jpg

[Brian8506]

Re: 1025IF Rebooting

That's what I want to do to this machine


Sent from my iPhone using Tapatalk

[teckat]

Re: 1025IF Rebooting

That's what I want to do to this machine


Sent from my iPhone using Tapatalk

============================================

remove DDR and power up printer without it see result


DDR module sits into Image Processor

[Brian8506]

Re: 1025IF Rebooting

Did that. Machine cycles but no display


Sent from my iPhone using Tapatalk

[teckat]

Re: 1025IF Rebooting

Did that. Machine cycles but no display


Sent from my iPhone using Tapatalk

put back---quickly try to get into
Service mode > Clear > ALL > Ok

[teckat]

Re: 1025IF Rebooting

Image Processor:

1025iF FM2-6088-020