[Dead] Canon 2020L

[savi0r]

Hello guys. Can anyone give me some advice about the error in the image attached, please? Thank you.

[ernesto]

Re: Canon 2020L

I think unit fixing is not working..
Before replacing anything enter in service mode .... copier>function>clear>error....turn off and turn on the machine

[teckat]

Re: Canon 2020L

Hello guys. Can anyone give me some advice about the error in the image attached, please? Thank you.

Remove fix unit to inspect.

:' -(
E003-0004
Thermistor open circuit detection.
In the period from initial rotation to printing, Sub Thermistor 2 detected a temperature of 40 deg C or lower for more than 3 seconds.

Remedy ; Fixing Assembly error, Fixing temperature detection error.
1. Check failure between the DC Controller PCB (UN09/ J12) and the Fixing Assembly (UN37/ J123, UN13/ J13) (trapped cable, open circuit, connector disconnection). -> Replace the part in the case of trapped cable/open circuit
2. Replace the Fixing Assembly
3. Replace the DC Controller PCB (UN09) NOTE: After performing the above remedy work, go through the following to clear the error:
COPIER > FUNCTION > CLEAR > ERR

[savi0r]

Re: Canon 2020L

Anyone can help me with a service manual, please?

[teckat]

Re: Canon 2020L

Enter Service Mode
COPIER > FUNCTION > CLEAR>ERR
Clear of error code
-To clear error codes (E000, E001, E002, E003, E717, E719).
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.