Irc 3200 error e602-0202

[bicool]

Hi,all
I got E602-0202 When I was booting up the machine. This error showed up just after standby screen came out only 2 seconds. I've already switched HDD with another one from working machine, but same error. I don't want to format and reload firmware on HDD coz I don't think it is bad.Are there any other reasons caused this error? Any idea would be greatly appreciated.

[Kopyrtek]

If, after checking and replacing the Hard Drive and the Main Controller the problem is not resolved, suspect a faulty SRAM PCB.The SRAM PCB is a contolled item so you would have to contact Canon to get one.
Thats about all i could find on that particular code.

[prada]

HDD might be fine, but filmware could be corrupted, so at least give it a try!

[prada]

Sorry hit the wrong key, before finished!, cont, swapping the HDD with a know working can generate error code if different filmware from boot ROM, did you put the original HDD on a know working machine to elimate HDD?

[bicool]

Thanks for replys! Yes, I did not try this HDD on another known working machine, I will give it a try...

[Oze]

Never actually had a 3200 drive die but the procedure will be the same as for a 5000 5.25 ide drive.

[bicool]

Hi, Oze
Could u explain what procedure is? Thx a lot.

[wingnut132]

Clear RAM of the SRAM in service mode [COPIER> Function> CLEAR> MN-CON].
If the symptom still recurs, replace the SRAM Board PCB with a new one.
Note: Clearing the RAM or replacement of the SRAM Board PCB will erase all the image data inside the HDD.
FG3-2856 SRAM Board PCB Ass'y